EASA orders more frequent de-icing valve checks on ATR 42 and ATR 72 fleets under AD 2026-0219
Why It MattersShortened intervals on a single bleed-air component show how turboprop icing protection is managed through maintenance frequency, which moves cost and aircraft availability onto operators of ageing regional fleets.
What happened
The European Union Aviation Safety Agency (EASA) has ordered more frequent inspections of the de-icing systems on ATR 42 and ATR 72 turboprop aircraft. Airworthiness directive AD 2026-0219, issued on November 16, addresses potentially undetected failures that could lead to loss of control during flight in icing conditions. It covers all aircraft in the ATR 42 and ATR 72 families, including newer variants, replaces an earlier directive issued in January 2025, and takes effect on November 30.

The requirements focus on the pressure regulator and shut-off valves (PRSOVs), which control the supply of hot air used by the de-icing system to prevent ice accumulation on critical surfaces. EASA said a design review identified the need to shorten the intervals between functional tests of these valves, and a subsequent failure modes and effects analysis by the supplier established that even more frequent checks were needed to meet safety requirements.
Under the revised directive, functional tests must be performed every 160, 190 or 210 flight hours, depending on aircraft configuration and incorporated modifications. Transitional requirements set when the first inspection must be completed. If a malfunction is found, operators must complete corrective actions before the next flight. Where existing maintenance instructions provide no approved solution, operators must obtain repair instructions from ATR.
The directive follows the final report by Brazil's Aeronautical Accidents Investigation and Prevention Center (Cenipa), published on July 23, 2026, on the August 9, 2024 crash of a Voepass ATR 72-500. Investigators found the aircraft encountered conditions conducive to severe icing, and identified recurring de-icing system malfunctions, maintenance deficiencies and shortcomings in the crew's response to warnings. Ice accumulation degraded aerodynamic performance, contributing to a stall and loss of control. Cenipa issued safety recommendations to EASA and ATR.
Two other ATR directives in November
EASA issued two other ATR-related directives in November. AD 2026-0217, published on November 12, shortens the time allowed to inspect horizontal stabilizer structural components after reports of loose fasteners and cracks; certain ATR 42-500 and ATR 72-212A aircraft must now be inspected within 20 months of May 28, 2025, instead of 24 months.
AD 2026-0215, issued on November 6, addresses a potential assembly defect in pressure regulators of passenger oxygen systems that could prevent oxygen flow on activation. Affected aircraft must be inspected within six months or 750 flight hours.
Industry impact & what to watch
A directive that shortens a functional-test interval changes the economics of a fleet without touching its design. For turboprop operators, the cost shows up as added maintenance visits and downtime counted in flight hours, and it falls hardest on carriers whose aircraft fly many short sectors and so reach the 160-, 190- or 210-hour marks quickly.
The three November directives also show a pattern in how regulators manage a mature type: through successive adjustments to inspection intervals and scope, each tightening one system at a time. Operators of ATR 42 and ATR 72 aircraft face a cluster of compliance dates, covering de-icing valves, stabilizer structure and oxygen regulators, that maintenance planners must sequence together.
The next fixed point is November 30, when AD 2026-0219 takes effect and the transitional deadlines for the first valve test begin to run.

















































