logo_tag
Back

EASA Revises SIB 2026-04 on Introducing Jet A Fuel Into Jet A-1 Supply Environments, Removing Winter Time Limit

Why It MattersDropping the seasonal cut-off treats Jet A as a possible longer-lasting supplement to Jet A-1 in Europe, shifting attention from a temporary workaround to standing fuel-quality and handling controls.

Europa

What happened

The European Union Aviation Safety Agency (EASA) has issued Revision 1 of Safety Information Bulletin (SIB) 2026-04, covering the possible introduction of Jet A turbine fuel at European locations traditionally supplied with Jet A-1. The bulletin cites recent events in global aviation fuel supply chains that may constrain Jet A-1 availability on certain markets. It is addressed to fuel suppliers and producers, organisations storing and dispensing fuel at aerodromes, National Competent Authorities, aircraft operators, aerodrome operators and Design Approval Holders.

EASA Revises SIB 2026-04 on Introducing Jet A Fuel Into Jet A-1 Supply Environments, Removing Winter Time Limit

The revision confirms that the original recommendations remain valid and removes the winter season time limit. Further revision or cancellation will depend on how events evolve. EASA does not consider the concern an unsafe condition warranting an Airworthiness Directive under Regulation (EU) 748/2012 or a Safety Directive under Regulation (EU) 965/2012.

EASA identifies several risks: reduced freezing point margins of Jet A versus Jet A-1, lower electrical conductivity where Static Dissipator Additive is not used, fuel grade confusion in communication between suppliers, ground handlers, flight crews and airlines, and differences between the ASTM D1655 and Def Stan 91-091 quality assurance frameworks. It notes that Jet A is used daily in the USA and Canada and that its introduction would not raise safety concerns if properly managed, but that European infrastructure has not necessarily been fully risk-assessed for low-conductivity fuels.

EASA recommends that Jet A continue to be handled in line with Def Stan 91-091, except for two parameters: a maximum freezing point of -40 °C and maximum total acidity of 0.10 mg KOH/g (per ASTM D1655). Electrical conductivity should remain within 50-600 pS/m, and fuel batch traceability is expected. The AFQRJOS Checklist (Issue 36B) should be used, or equivalent controls demonstrated.

In commingled systems, fuel should be used according to the most limiting specification, which may mean it is designated and handled as Jet A. All stakeholders connected to a commingled system should be consulted.

Industry impact & what to watch

Taking the winter season limit out of the bulletin changes how the guidance reads. A seasonal restriction signals a stopgap tied to a particular stretch of the year; without it, the recommendations stand as open-ended handling guidance for any European location that ends up receiving Jet A. For fuel suppliers and into-plane operators, the practical consequence is that the controls EASA lists, from conductivity limits to batch traceability, become part of routine quality assurance rather than a temporary overlay.

The risks EASA names are largely about interfaces, not the fuel itself. Jet A and Jet A-1 are both handled widely elsewhere, but Europe's storage, dispensing and communication practices were built around Def Stan 91-091. Grade confusion between suppliers, ground handlers, flight crews and airlines, and the treatment of commingled systems under the most limiting specification, are where a mixed-fuel environment can strain existing procedures.

EASA ties any further revision or cancellation to how events in global fuel supply chains evolve, so the bulletin's next change will follow supply conditions rather than a calendar date. Until then, the SIB stays non-mandatory, with EASA explicitly declining to treat the matter as an unsafe condition.

Original Source

EASA_SIB_2026_04R1Europa
Keep Exploring